Abstract
Higher alcohols and esters are among the predominant classes of volatile organic compounds (VOCs) that influence the quality of beer. The concentrations of these compounds are determined through a specific yeast strain selection and fermentation conditions. The effect of yeast strains on the formation of higher alcohols and esters throughout fermentations (at 20 & DEG;C) was investigated. Flavour-relevant esters (ethyl acetate, isoamyl acetate, ethyl hexanoate and ethyl octanoate) and higher alcohols (isoamyl alcohol, isobutyl alcohol and phenylethyl alcohol) were monitored throughout the fermentation using proton transfer reaction-time of flight-mass spectrometry (PTR-ToF-MS) coupled with an automated sampling system for continuous measurements. Compound identification was confirmed by analysis of samples using gas chromatography-mass spectrometry (GC-MS). Results demonstrated the specific time points where variation in higher alcohol and ester generation between yeast strains occurred. In particular, the concentrations of isoamyl acetate, ethyl octanoate and isoamyl alcohol between yeast strains were significantly different over the first 2 days of fermentation; whereas, after Day 3, no significant differences were observed. The two Saccharomyces pastorianus strains produced comparable concentrations of the key higher alcohols and esters. However, the key higher alcohol and ester concentrations varied greatly between the two S. cerevisiae strains. The use of PTR-ToF-MS to rapidly measure multiple yeast strains provides new insights on fermentation for brewers to modify the sensory profile and optimise quality.