Abstract
Biofilm formation around orthodontic appliances causes gingivitis, enamel decalcification and caries. Bacteria adhere less readily to superhydrophobic surfaces. The aim of this study was to determine whether a superhydrophobic surface could be generated on orthodontic elastomers by surface modification in order to reduce bacterial adhesion.
Orthodontic elastomers were modified with sandpapers of various grit sizes (80–600 grit). Surface roughness of the modified and unmodified surfaces was assessed qualitatively with scanning electron microscopy and quantitatively with confocal microscopy. Water contact angles were measured with a goniometer to quantify hydrophobicity. Measurements were performed on unextended elastomers (100% original length) and elastomers extended to 150%, and 200% of the original length. Adhesion of Streptococcus gordonii to saliva coated elastomers was measured by counting colony forming units on agar plates.
Abrasion with different sandpapers produced elastomers with surface roughness (Ra) ranging from 2 to 12 μm. Contact angles followed a quadratic trend with a maximum contact angle of 104° at an Ra of 7–9 μm. Average water contact angles, when viewed perpendicular to the direction of extension, decreased from 99° to 90° when the extension was increased from 100% to 200% and increased from 100° to 103° when viewed parallel to the direction of extension. Bacterial adhesion increased as roughness increased and this effect was more pronounced with elastomer extension.
The surface roughness of orthodontic elastomers influences both their hydrophobicity and bacterial adhesion. Superhydrophobicity of elastomers could not be achieved with sandpaper abrasion.